Drive: 1.9″ diameter powered rollers (MDR motor driven rollers).
Motor: 24v DC.
Controls: Drive cards and zone photo-eyes mounted under conveyor frame.
Speed: Variable from 20 to 190 FPM.
Bed: 18” wide roller bed with 1.9″ dia. x 16 gauge galvanized steel rollers spaced on 3” centers with 7/16” hex, spring loaded axles, ABEC-1 bearings.
Supports: Floor or ceiling supported.
Guard rail: Angle type “A” (facing inward) both sides.
Zones: Standard zone length is 24″ long. Option to go up to 36″ and beyond.
Finish: All normally painted parts are powder painted grey. Stainless steel option available.
Also available in 50mm dia roller.
Wash Down Roller Features:
Drive: 1.9″ diameter powered rollers (IP66).
Motor: 24v DC.
Controls: IP67 zone photo-eyes mounted under conveyor frame and control cards mounted in type 4X enclosure with watertight cord grips.
Speed: Variable from 20 to 190 FPM.
Bed: 18” wide roller bed with 1.9″ dia. x 16 gauge galvanized steel rollers spaced on 3” centers with 7/16” hex, spring loaded axles, ABEC-1 bearings.
Supports: Floor or ceiling supported.
Guard rail: Angle type “A” (facing inward) both sides.
Zones: Standard zone length is 24″ long.
Finish: 304 stainless steel.
Also available in 50mm dia roller.
1.38″ Roller Features:
Drive:1.38” diameter powered rollers.
Motor: 24v DC.
Controls: Drive cards and zone photo-eyes mounted above conveyor frame.
Speed: Variable from 20 to 190 FPM.
Bed: 18” wide roller bed with 1.38” diameter x 16 gauge galvanized steel rollers spaced on 1.5” centers with 7/16” hex, spring loaded axles, abec-1 bearings.
Supports: Floor or ceiling supported.
Guard rail: Angle type “A” (facing inward) both sides.
Zones: Standard zone length is 24″ long. Option to go up to 36″ and beyond.
Finish: All normally painted parts are powder painted grey. Stainless steel option available.
Power supply: 480v-3ph-60hz power supplies included.
